neutron-fwaas in DevStack

This is setup as a DevStack plugin. For more information on DevStack plugins, see the DevStack Plugins documentation.

Please note that the old ‘q-fwaas’ keyword still exists, and will run FWaaS V1. This default will be changed during the Ocata cycle. The introduction of two new keywords, ‘q-fwaas-v1’ and ‘q-fwaas-v2’ allow you to explicitly select the version you with to run.

How to run FWaaS V2 in DevStack

Add the following to the localrc section of your local.conf to configure FWaaS v2.

[[local|localrc]]
enable_plugin neutron-fwaas https://git.openstack.org/openstack/neutron-fwaas
enable_service q-fwaas-v2

To check a specific patchset that is currently under development, use a form like the below example, which is checking out change 214350 patch set 14 for testing.

[[local|localrc]]
enable_plugin neutron-fwaas https://review.openstack.org/p/openstack/neutron-fwaas refs/changes/50/214350/14
enable_service q-fwaas-v2

How to run FWaaS V1 in DevStack

Add the following to the localrc section of your local.conf to configure FWaaS v1.

[[local|localrc]]
enable_plugin neutron-fwaas https://git.openstack.org/openstack/neutron-fwaas
enable_service q-fwaas-v1

To check a specific patchset that is currently under development, use a form like the below example, which is checking out change 214350 patch set 14 for testing.

[[local|localrc]]
enable_plugin neutron-fwaas https://review.openstack.org/p/openstack/neutron-fwaas refs/changes/50/214350/14
enable_service q-fwaas-v1